RC-Monster Forums - View Single Post

scarletboa · 07.17.2010, 01:49 PM

so, as long as i don't let the cases touch, it should be fine? i would likely mount them securely on a shelf with about 6 inches between them.

i was already aware of the case being grounded on most PSUs. i found out on my own the hard way. it's a good thing the specific PSU i was using had a built-in short protector circuit thing that shut it down and wouldn't turn back on until after i unplugged it and plugged it back in.

	(#13)
scarletboa RC-Monster Aluminum Offline Posts: 929 Join Date: Mar 2009 Location: Las Vegas NV	07.17.2010, 01:49 PM so, as long as i don't let the cases touch, it should be fine? i would likely mount them securely on a shelf with about 6 inches between them. i was already aware of the case being grounded on most PSUs. i found out on my own the hard way. it's a good thing the specific PSU i was using had a built-in short protector circuit thing that shut it down and wouldn't turn back on until after i unplugged it and plugged it back in. They say a good mechanic only needs 2 tools - WD40 & Duct tape. If it moves, and its not supposed to, duct tape. If it doesn't move, and its supposed to, WD40.