[brijar]

I crimped the heat sink in a vise since it was a bit loose. Now it fits fairly tightly. It originally had some kind of heat compound on it, but not anymore. I just got back from a run and the temps were about 56 degreesC on the motor according to my FlashPoint. Everything went pretty well, except about halfway through the run, one of my front stock sliders broke at the drive hub leaving me with rear wheel drive. It was pretty fun because I could do donuts in the grass:005:! I was running 16/72 gearing with mostly high speed runs with a little bit of jumping. I had a fan on my rollcage, but it didn't seem to help much. I'm gonna try to get some pics up of my setup sooner or later. It still seems to have pretty bad cogging when going slow IMO. Is there anyway to fix that?

Thanx,
Brijar!!!