RC-Monster Forums - View Single Post - Quick question about soldering a motor & grinding a flat rotor spot.

What's_nitro? · 08.03.2010, 02:49 PM

The color of the wires means nothing. If the motor runs backwards, just switch any two of them.

I use a small flat file to make flats on motor shafts. If the motor has holes in the front make sure to tape them over.

	(#2)
What's_nitro? Soldermaster Extraordinaire Offline Posts: 4,529 Join Date: Apr 2007 Location: Plymouth, MA, USA	08.03.2010, 02:49 PM The color of the wires means nothing. If the motor runs backwards, just switch any two of them. I use a small flat file to make flats on motor shafts. If the motor has holes in the front make sure to tape them over.