RC-Monster Forums - View Single Post - Quick question about soldering a motor & grinding a flat rotor spot.

08.04.2010, 06:08 AM

Well, it's a regular shaft not from a motor. It will be used in an E-Bike to make the reduction. The motor I ordered (which is at the customs right now) has got a 12mm shaft (almost 1/2''), it's a Turnigy 130kv outrunner.

	(#11)
Byte Guest Posts: n/a	08.04.2010, 06:08 AM Well, it's a regular shaft not from a motor. It will be used in an E-Bike to make the reduction. The motor I ordered (which is at the customs right now) has got a 12mm shaft (almost 1/2''), it's a Turnigy 130kv outrunner.