RC-Monster Forums - View Single Post

DLS II · 08.15.2010, 05:27 PM

The width between the frame rails is 45mm. The diameter of the motor is 50mm. If I machine the inside of the frame rails 5mm on either side it should fit. I'll have to have a custom mount made. I was hoping it would have enough torque to overcome startup issues? I was looking at the 50-65-450 running 6s A123 with a MMM. Don

	(#3)
DLS II RC-Monster Carbon Fiber Offline Posts: 136 Join Date: May 2007	08.15.2010, 05:27 PM The width between the frame rails is 45mm. The diameter of the motor is 50mm. If I machine the inside of the frame rails 5mm on either side it should fit. I'll have to have a custom mount made. I was hoping it would have enough torque to overcome startup issues? I was looking at the 50-65-450 running 6s A123 with a MMM. Don