RC-Monster Forums - View Single Post - Suggest gearing for 9L on 14 cells and UE diffs

nitrostarter · 02.24.2006, 02:48 PM

E-Maxx-kid- I run the same 7xl on 16 IB3800's, but use a 18120 controller. My maxx weighs right at or over 12lbs RTR. I use UE diffs( so it adds 2 teeth to the pinion vversus stock diffs) and I'm running 18/51. I also have a 16T I want to try out. I would have had a 20T also but Mike was out of them. 18/51 is insane on 16cells, although the motor will reach about 150-165 degrees after a run, other than that everything else is good.

O, my other problem is staying off the body and grinding my antenna in half. For some reason I keep flipping onto it body and it slides, catching the antenna under the body, and it grinds the tube and wire in half.

	(#30)
nitrostarter RC-Monster Brushless Offline Posts: 3,156 Join Date: Jul 2005 Location: Gramercy, LA	02.24.2006, 02:48 PM E-Maxx-kid- I run the same 7xl on 16 IB3800's, but use a 18120 controller. My maxx weighs right at or over 12lbs RTR. I use UE diffs( so it adds 2 teeth to the pinion vversus stock diffs) and I'm running 18/51. I also have a 16T I want to try out. I would have had a 20T also but Mike was out of them. 18/51 is insane on 16cells, although the motor will reach about 150-165 degrees after a run, other than that everything else is good. O, my other problem is staying off the body and grinding my antenna in half. For some reason I keep flipping onto it body and it slides, catching the antenna under the body, and it grinds the tube and wire in half. N. Rustler conversion