RC-Monster Forums - View Single Post

Bondonutz · **Finially a UPDATE ! -** 08.21.2010, 02:48 PM

I finially have the TVP's cut out, They fit the bulkheads pretty good except a couple tiny spots where the radius is a tick off. I can def live w/it.

As of right now the Wheel Base is 24-1/4", not real sure I want to keep it this long. I was thinking 20-21" would be more than enough but I want mine to be different so IDK ?

I hadn't planned on running a body hence the high area/wanna be cab. These large bodies are nearly a $100.00 or more and they just get trashed from all the weight ?

I have yet to do the cut outs to lighten it, figured I save that for when I'm close to completion. I need to do the finishing touches on the other TVP and then decide where the tranny/batterys are going. Then I have to make braces and center axles.

	(#8)
Bondonutz Fat Kid Engineering Offline Posts: 3,634 Join Date: Jun 2009 Location: Hot as Hell West Central Coast Florida	Finially a UPDATE ! - 08.21.2010, 02:48 PM I finially have the TVP's cut out, They fit the bulkheads pretty good except a couple tiny spots where the radius is a tick off. I can def live w/it. As of right now the Wheel Base is 24-1/4", not real sure I want to keep it this long. I was thinking 20-21" would be more than enough but I want mine to be different so IDK ? I hadn't planned on running a body hence the high area/wanna be cab. These large bodies are nearly a $100.00 or more and they just get trashed from all the weight ? I have yet to do the cut outs to lighten it, figured I save that for when I'm close to completion. I need to do the finishing touches on the other TVP and then decide where the tranny/batterys are going. Then I have to make braces and center axles. I retired from RC, now life is all about guns and long range shooting.