RC-Monster Forums - View Single Post - My e-revo brushless edition build

mistercrash · 10:52 AM

I didn't have major heat issues with the MMM in my ERBE but under very hard bashing, going at it non stop for 25/30 until the LVC kicks in, the motor would reach temps close to 180. So for extra protection, I put this fan on. Got it from ebay, it wasn't meant to fit the CC 1515 but I made it fit by sawing off 1/3 of the heat sink, then spreading the part left to make it fit snug on the motor. Held with two zip ties.

	(#659)
mistercrash Guelph, Canada, eh! Offline Posts: 1,083 Join Date: Sep 2007 Location: Guelph, Ontario, Canada	This is for BrianG - 08.25.2010, 10:50 AM I didn't have major heat issues with the MMM in my ERBE but under very hard bashing, going at it non stop for 25/30 until the LVC kicks in, the motor would reach temps close to 180. So for extra protection, I put this fan on. Got it from ebay, it wasn't meant to fit the CC 1515 but I made it fit by sawing off 1/3 of the heat sink, then spreading the part left to make it fit snug on the motor. Held with two zip ties. No brain, no headaches. Last edited by mistercrash; 08.25.2010 at 10:52 AM.