RC-Monster Forums - View Single Post

rawfuls · **BEC and Shorting Question.. -** 09.06.2010, 10:34 PM

So, earlier today, I flipped, no biggie. No body, but I believe I pulled the RX wires out of the BEC.

These:

So, I found it, the signal wire was completely off the BEC, the pos and neg wires were starting to lift off, strands may have been touching each other.

I got magic smoke on my fans (fan on ESC, and motor, yeah yeah BrianG..), my servo, but not the ESC.. Not that I know of.

So my question...
Would the fans and servo shortage and smokage be caused from the BEC short?
If I were to reuse the BEC, and it shorted again, what, if anything, would short out?
RX?

Thanks!

	(#1)
rawfuls roofles. Offline Posts: 1,982 Join Date: Oct 2008 Location: Woodland Hills, CA	BEC and Shorting Question.. - 09.06.2010, 10:34 PM So, earlier today, I flipped, no biggie. No body, but I believe I pulled the RX wires out of the BEC. These: So, I found it, the signal wire was completely off the BEC, the pos and neg wires were starting to lift off, strands may have been touching each other. I got magic smoke on my fans (fan on ESC, and motor, yeah yeah BrianG..), my servo, but not the ESC.. Not that I know of. So my question... Would the fans and servo shortage and smokage be caused from the BEC short? If I were to reuse the BEC, and it shorted again, what, if anything, would short out? RX? Thanks!