RC-Monster Forums - View Single Post - 1717 in a Desert Boy Chassis, It can be done !

Bondonutz · 05:39 PM

Finially finished the entire assembly, Had insomnia last night and was balanceing tires at 4am. I haven't ben feeling the greatest the last couple days so I may not test until Monday or Tuesday ?

I installed the ESC(pulled red wire) , 1200mah 2s ThunderPower RX battery and RX on battery tray, lots of room for electronics there.

Mounted and balanced PL Trenchers on 23mm 40series 1/2" offset Dyed PL Velocitys

The XL body doesn't fit to bad, Think the next thing I may consider makeing will be a roll cage for the cab and tie into the F&R shock towers ? A roll over w/this Heavy assed MoFo will destroy some Polycarbonate.
Time to look for some 1/4" 7075 solid rod and fire up my aluminum welder.

	(#29)
Bondonutz Fat Kid Engineering Offline Posts: 3,634 Join Date: Jun 2009 Location: Hot as Hell West Central Coast Florida	10.03.2010, 03:53 PM Finially finished the entire assembly, Had insomnia last night and was balanceing tires at 4am. I haven't ben feeling the greatest the last couple days so I may not test until Monday or Tuesday ? I installed the ESC(pulled red wire) , 1200mah 2s ThunderPower RX battery and RX on battery tray, lots of room for electronics there. Mounted and balanced PL Trenchers on 23mm 40series 1/2" offset Dyed PL Velocitys The XL body doesn't fit to bad, Think the next thing I may consider makeing will be a roll cage for the cab and tie into the F&R shock towers ? A roll over w/this Heavy assed MoFo will destroy some Polycarbonate. Time to look for some 1/4" 7075 solid rod and fire up my aluminum welder. I retired from RC, now life is all about guns and long range shooting. Last edited by Bondonutz; 10.03.2010 at 05:39 PM.