Quote:
Originally Posted by Jahay
wow those actually look like real good quality from integy!
I was just thinking though that when installed, it is pushed up agsint the end part of teh bearing... does it offer any restriction or friction when turning? or is the centre of the bearing not in contact wth the hex?
These seem like a much better idea than the XL Axles!
do these fit onto stock axles or xl axles?
|
Should be for the stock Flux axles. Hopefully I didnt miss anything in that thread because now I cant find it. I'm sure the spacing between the bearing shouldn't be an issue. We'll find out soon enough though