|
02.28.2006, 10:09 PM
The switch is reversed from standard switches - if you cut it off and connect the wires from it together, the controller is off.
Continuous beeping usually means no radio signal. Are you sure it is plugged into the RX correctly? It could also mean incorrect cell count, which would be accounted for in the programming.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|