RC-Monster Forums - View Single Post

Bmr4life · 01:18 PM

With a thinner or different material, I would agree.

Mine is made from 1/4" 316 stainless steel. I work in a factory and tested another piece I had in 4 ton arbor press. Maxed out the press and it was only slightly bent. It ain't flexing in this truck.

I thought I remembered your mount. How thick was it, 3/16 or 1/8". With that, I would have agreed a support was needed.

http://www.rc-monster.com/forum/show...80&postcount=8

	(#24)
Bmr4life RC-Monster Carbon Fiber Offline Posts: 453 Join Date: Mar 2006	10.23.2010, 01:11 PM With a thinner or different material, I would agree. Mine is made from 1/4" 316 stainless steel. I work in a factory and tested another piece I had in 4 ton arbor press. Maxed out the press and it was only slightly bent. It ain't flexing in this truck. I thought I remembered your mount. How thick was it, 3/16 or 1/8". With that, I would have agreed a support was needed. http://www.rc-monster.com/forum/show...80&postcount=8 Last edited by Bmr4life; 10.23.2010 at 01:18 PM.