RC-Monster Forums - View Single Post

magman · 09:07 PM

The 2250 on 4s would be better due to the motor being designed more towards the truggy line. Also, if you use the mm pro I would install an external bec to help ease the temps a bit due the the weight of the truggy.

In saying this, your set up will work just pay close attention to temps

I run the mmm w/the 1520 on 5s in my Truggy and it runs cool as can be. My set up is overkill, but it runs great!

	(#2)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	11.04.2010, 09:04 PM The 2250 on 4s would be better due to the motor being designed more towards the truggy line. Also, if you use the mm pro I would install an external bec to help ease the temps a bit due the the weight of the truggy. In saying this, your set up will work just pay close attention to temps I run the mmm w/the 1520 on 5s in my Truggy and it runs cool as can be. My set up is overkill, but it runs great! 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S Last edited by magman; 11.04.2010 at 09:07 PM.