RC-Monster Forums - View Single Post

rcobscession · 12.04.2010, 12:37 AM

I'm new to this forum but definitely not brushless rc and especially not the savage flux. I have to say i run my flux hard and i have never felt the need to go plastic on the spur nor have i heard of anyone using correct mesh needing to go plastic. I actually still have the original stock 20t pinion still going strong. Also i had my flux at xl length and width and it lost almost all of its "nimbleness" it had to it so my solution was to go back to stock length while leaving the flm extended arms on. It doesn't flip, handles well, and still feels like it did when i bought it.

	(#22)
rcobscession RC-Monster Stock Offline Posts: 15 Join Date: Oct 2010 Location: pa	12.04.2010, 12:37 AM I'm new to this forum but definitely not brushless rc and especially not the savage flux. I have to say i run my flux hard and i have never felt the need to go plastic on the spur nor have i heard of anyone using correct mesh needing to go plastic. I actually still have the original stock 20t pinion still going strong. Also i had my flux at xl length and width and it lost almost all of its "nimbleness" it had to it so my solution was to go back to stock length while leaving the flm extended arms on. It doesn't flip, handles well, and still feels like it did when i bought it.