RC-Monster Forums - View Single Post - Computer supplys for charger power question

J57ltr · 01.09.2011, 05:54 PM

Well you are answering faster than I can find the onfo. lol

This is what I have:

Power to jacks= All the 18 gauge yellows + / an equal amount of Blacks -

10 ohm 5w resistor (Do you think I need to use a 5ohm resistor for a 1 amp load?)

Red
Black

Switch

Green
Black

On the large Molex:

There is a small gauge gray crimped to an 18 ga Orange inserte into the same terminal. (On my old powersupply these wires were soldered inside the case when I converted it)

Other wires are:

Blue -12V ?
small gray
multiple Orange
small purple

	(#5)
J57ltr RC-Monster Aluminum Offline Posts: 610 Join Date: Feb 2009 Location: Tomball/ Houston Tx.	01.09.2011, 05:54 PM Well you are answering faster than I can find the onfo. lol This is what I have: Power to jacks= All the 18 gauge yellows + / an equal amount of Blacks - 10 ohm 5w resistor (Do you think I need to use a 5ohm resistor for a 1 amp load?) Red Black Switch Green Black On the large Molex: There is a small gauge gray crimped to an 18 ga Orange inserte into the same terminal. (On my old powersupply these wires were soldered inside the case when I converted it) Other wires are: Blue -12V ? small gray multiple Orange small purple The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product.