RC-Monster Forums - View Single Post

MetalMan · 03.10.2006, 06:11 PM

I could use my ICE charger with its variable voltage output to imitate a 2s Lipo battery, with a controller and motor attached, hooked up to the LVC device and a receiver. The voltage would start out anywhere above 6v, and then I would take it below 6v to test how the LVC device causes the motor to operate. Besides, there is no evidence that a LiSaver will work as planned.

If I had $20 to spare, I would buy the Dimension Engineering LVC, but unfortunately I already have my next $150+ planned out (that'll take me a few months to get).

	(#27)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	03.10.2006, 06:11 PM I could use my ICE charger with its variable voltage output to imitate a 2s Lipo battery, with a controller and motor attached, hooked up to the LVC device and a receiver. The voltage would start out anywhere above 6v, and then I would take it below 6v to test how the LVC device causes the motor to operate. Besides, there is no evidence that a LiSaver will work as planned. If I had $20 to spare, I would buy the Dimension Engineering LVC, but unfortunately I already have my next $150+ planned out (that'll take me a few months to get). SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz