RC-Monster Forums - View Single Post

gtxracer · 10:06 PM

I put the smallest pinion I could fit on the there but they strip out very easily due to motor plate flex. I have a couple brass pinions but my 20mm Castle motor and 3s lipos should be here soon. I already have a NIB Quark 22A ready to go for this little rig.

Oh and it still likes to shut down after minimal run time. I think it's due to the load on the motor. I might get a Micro-T just to put in the Xcelorin system and have 1/36 fun.

	(#1)
gtxracer HOOH HUAH HOOH! Aww Baby! Offline Posts: 868 Join Date: Oct 2007 Location: olyWA	02.12.2011, 10:05 PM I put the smallest pinion I could fit on the there but they strip out very easily due to motor plate flex. I have a couple brass pinions but my 20mm Castle motor and 3s lipos should be here soon. I already have a NIB Quark 22A ready to go for this little rig. Oh and it still likes to shut down after minimal run time. I think it's due to the load on the motor. I might get a Micro-T just to put in the Xcelorin system and have 1/36 fun. :D Last edited by gtxracer; 02.12.2011 at 10:06 PM.