RC-Monster Forums - View Single Post - My e-revo brushless edition build

Ola · 02.13.2011, 03:03 PM

My bearings fit perfect in my RPM carriers..

The problem most have with them, is pivot`s popping out.. I think the RPM`s are supposed to use the metal rings around pivot`s on the inside of the carrier. They fit 100% perfect (very tight too), so i suspect it`s ment to be like that.
You have to take the metal rings from stock carriers though, since they dont come with the RPM`s..

Not sure it cures the problem 100%, but i think so.

	(#716)
Ola RC-Monster Carbon Fiber Offline Posts: 118 Join Date: Feb 2011 Location: Norway	02.13.2011, 03:03 PM My bearings fit perfect in my RPM carriers.. The problem most have with them, is pivot`s popping out.. I think the RPM`s are supposed to use the metal rings around pivot`s on the inside of the carrier. They fit 100% perfect (very tight too), so i suspect it`s ment to be like that. You have to take the metal rings from stock carriers though, since they dont come with the RPM`s.. Not sure it cures the problem 100%, but i think so. RC8T FT CE, CC1520, Tekno v4