RC-Monster Forums - View Single Post - My e-revo brushless edition build

Ola · 03:23 PM

Yeah, mine front axle was also grinded down some.. Strange my rear fit so good then, but anyway you seem to be all good now!

My diffs where also _very_ tight.. I removed a shim from the ingoing "pinion" drive, and the mesh felt perfect after that.. They where so tight, that i belive it would be a problem.. I had problems tuning them with my fingers in the pinion drive, without cups on.. And they where noisy when turning them fast.

	(#6)
Ola RC-Monster Carbon Fiber Offline Posts: 118 Join Date: Feb 2011 Location: Norway	02.15.2011, 03:14 PM Yeah, mine front axle was also grinded down some.. Strange my rear fit so good then, but anyway you seem to be all good now! My diffs where also _very_ tight.. I removed a shim from the ingoing "pinion" drive, and the mesh felt perfect after that.. They where so tight, that i belive it would be a problem.. I had problems tuning them with my fingers in the pinion drive, without cups on.. And they where noisy when turning them fast. RC8T FT CE, CC1520, Tekno v4 Last edited by Ola; 02.15.2011 at 03:23 PM.