RC-Monster Forums - View Single Post - hpi 86376 discontinued - Hinge Pin

FG101C · 02.24.2011, 05:55 PM

You could use stainless rod, cut it 60mm, thread 5mm on each end and use locknuts. Did that with my losi 8t because it would bend the rear outer pins, never bent a stainless one.

	(#18)
FG101C RC-Monster Aluminum Offline Posts: 765 Join Date: Aug 2007	02.24.2011, 05:55 PM You could use stainless rod, cut it 60mm, thread 5mm on each end and use locknuts. Did that with my losi 8t because it would bend the rear outer pins, never bent a stainless one.