RC-Monster Forums - View Single Post

lincpimp · 02.24.2011, 10:04 PM

Ok, my 4 flute 12mm endmill arrived today. I will try to make some progress tomorrow after work. I need to figure a way to hold the rear hub without distorting it, but make sure it stays parallel to the cutting face of the endmill. I have a few ideas.

	(#79)
lincpimp Check out my huge box! Offline Posts: 11,935 Join Date: Aug 2007 Location: Slidell, LA	02.24.2011, 10:04 PM Ok, my 4 flute 12mm endmill arrived today. I will try to make some progress tomorrow after work. I need to figure a way to hold the rear hub without distorting it, but make sure it stays parallel to the cutting face of the endmill. I have a few ideas. Alot of Savage parts for sale!!!