RC-Monster Forums - View Single Post

lincpimp · 02.24.2011, 11:48 PM

Yes, it will be on a drill press. You would laugh if you saw me setup stuff like this.

I have an small vice that bolts to the press table. I am thinking I can make a platform with a slot in it that will hold the upper portion of the hub, and them use some material on either side of the bottom area to clamp the hun in place. The platform will hold the hub perpendicular to the endmill, and the spacers will stop the hub rotating.

I like your wax idea, but I would have to do one side at a time, remove the wayx, and them reset the hub the other way around in the wax to do the other side.

I have a way to "precisely" center the hub so that I get the bearing centered, again you would laugh if I described it.

The delrin would be handy, I cannot leave work due to family issues and lack of staff, but would gladly pay the shipping.

	(#83)
lincpimp Check out my huge box! Offline Posts: 11,935 Join Date: Aug 2007 Location: Slidell, LA	02.24.2011, 11:48 PM Yes, it will be on a drill press. You would laugh if you saw me setup stuff like this. I have an small vice that bolts to the press table. I am thinking I can make a platform with a slot in it that will hold the upper portion of the hub, and them use some material on either side of the bottom area to clamp the hun in place. The platform will hold the hub perpendicular to the endmill, and the spacers will stop the hub rotating. I like your wax idea, but I would have to do one side at a time, remove the wayx, and them reset the hub the other way around in the wax to do the other side. I have a way to "precisely" center the hub so that I get the bearing centered, again you would laugh if I described it. The delrin would be handy, I cannot leave work due to family issues and lack of staff, but would gladly pay the shipping. Alot of Savage parts for sale!!!