RC-Monster Forums - View Single Post

J57ltr · 03:03 PM

Believe me if you saw half the ghetto stuff I have to do. I am in the middle of R&D on a new scale and I have 2 precision blocks welded to a 3/8" thick plate. I had our welder make it for me and he just tacked it in place. One was about .5* off and I had to cut and tack it back in place then weld it across to make it stronger but when I did, everything shifted on me (as SST does). So I had to use a precision hammer to beat it back into place, precisely. So no I wouldn't laugh.

Let me know I'll cut you some blocks of Delrin in the morning. I have some that is 2" thick and is flat top and bottom. I also have 1" thick and some other sizes.

Jeff

	(#6)
J57ltr RC-Monster Aluminum Offline Posts: 610 Join Date: Feb 2009 Location: Tomball/ Houston Tx.	02.25.2011, 12:14 AM Believe me if you saw half the ghetto stuff I have to do. I am in the middle of R&D on a new scale and I have 2 precision blocks welded to a 3/8" thick plate. I had our welder make it for me and he just tacked it in place. One was about .5* off and I had to cut and tack it back in place then weld it across to make it stronger but when I did, everything shifted on me (as SST does). So I had to use a precision hammer to beat it back into place, precisely. So no I wouldn't laugh. Let me know I'll cut you some blocks of Delrin in the morning. I have some that is 2" thick and is flat top and bottom. I also have 1" thick and some other sizes. Jeff The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product. Last edited by J57ltr; 02.25.2011 at 03:03 PM. Reason: remove the double negative