RC-Monster Forums - View Single Post - how to reverse a servo in this application?

noir522 · 08:53 PM

actually doing it by the videos was a piece of cake. I am semi bad at soldering, but I did my Hobbywing mg995 with ease - 10 minutes and they were done, the biggest issues was making certain I would not later on confuse them with my normal direction servos. Note: this may not work on all Traxxas servos. The internals are not wired, they are merely soldered in contact via close proximation. But yea if the radio supports channel mixing. . . .

	(#16)
noir522 RC-Monster Stock Offline Posts: 23 Join Date: Oct 2009	02.26.2011, 08:52 PM actually doing it by the videos was a piece of cake. I am semi bad at soldering, but I did my Hobbywing mg995 with ease - 10 minutes and they were done, the biggest issues was making certain I would not later on confuse them with my normal direction servos. Note: this may not work on all Traxxas servos. The internals are not wired, they are merely soldered in contact via close proximation. But yea if the radio supports channel mixing. . . . Last edited by noir522; 02.26.2011 at 08:53 PM.