[simplechamp]

Originally Posted by BrianG

For future reference, those empty solder holes on the edge may be an alternate place to solder the cap. I can see there is at least a ground point, and I imagine there is a power point there too (would have to do some circuit tracing to be sure).

I was actually just about to ask what those were for. Might have to open it back up and do some more snooping around.

Originally Posted by Shonen

looking good, but I would recommend using an adhesive that isn't CA based when it's that close to electronics.

http://www.teamnovak.com/products/in...ca_warning.htm

That's good to know for next time. I really only used like 2 drops, so hopefully it will be OK.