RC-Monster Forums - View Single Post - To bec or not to bec that is the question

slimthelineman · 03.30.2011, 05:58 PM

Wow that sucks, never checked what kind of current I was drawing. Maybe I'm just lucky, ha ha ha. What kind of motors were you running on those setups with the issues. I've always ran like 3400kv or less on 3s and higher not sure if that has anything to do with it. The only time I had an issue was with a 4.5 550 on 2s I used in my scrt10. But it wasn't the digital servo that did it. Was only when I would punch it off the line I would get a brown out. Cap fixed it, but switched back to my fav setup of a 6.5 550 on 3s.

	(#10)
slimthelineman RC-Monster Aluminum Offline Posts: 608 Join Date: Jul 2008 Location: IBEW	03.30.2011, 05:58 PM Wow that sucks, never checked what kind of current I was drawing. Maybe I'm just lucky, ha ha ha. What kind of motors were you running on those setups with the issues. I've always ran like 3400kv or less on 3s and higher not sure if that has anything to do with it. The only time I had an issue was with a 4.5 550 on 2s I used in my scrt10. But it wasn't the digital servo that did it. Was only when I would punch it off the line I would get a brown out. Cap fixed it, but switched back to my fav setup of a 6.5 550 on 3s.