RC-Monster Forums - View Single Post - Custom Bits made from Bullet Proof polycarb material- See through!

JERRY2KONE · **Poly carbonite options. -** 04.14.2011, 02:11 AM

Hey Guy good to see you still hanging around in here. I remember your lit up tranny project. That was pretty cool. Where there is a will, there is a way. Too bad you couldn't use one of those 3D printers and make stuff from poly carbonite that way. Just think, you could lay in a stock TRX bulkhead and out would come a fully bulletproof replacement in just minutes.

	(#4)
JERRY2KONE JERRY2KONE SUPERMAXX Offline Posts: 3,452 Join Date: Sep 2006 Location: HAYMARKET VIRGINIA	Poly carbonite options. - 04.14.2011, 02:11 AM Hey Guy good to see you still hanging around in here. I remember your lit up tranny project. That was pretty cool. Where there is a will, there is a way. Too bad you couldn't use one of those 3D printers and make stuff from poly carbonite that way. Just think, you could lay in a stock TRX bulkhead and out would come a fully bulletproof replacement in just minutes. SUPERMAXX YOUR LIFE.