RC-Monster Forums - View Single Post

11:22 AM

Thank's !!

The shaft ....., yes, the torque of the motor unscrewed the shafts
so i make a small spot weld ...., yes, the torque of the motor unscrewed the spot welded shafts, too.

ESC/Motor:
Tekin RX8/ T8 1700kV / Lipo 5s

next step make a 360deg butt weld

a little overview

if i fiind somebody to hold the cam, i'll make a short vid today

but the thing is the next chassis to optimize the weight distribution is nearly done.

the CAD- Work for that revotruggy thing is in a phase to show you guys (in a new Thread)

	(#60)
Delta Maxx Guest Posts: n/a	04.18.2011, 11:20 AM Thank's !! The shaft ....., yes, the torque of the motor unscrewed the shafts so i make a small spot weld ...., yes, the torque of the motor unscrewed the spot welded shafts, too. ESC/Motor: Tekin RX8/ T8 1700kV / Lipo 5s next step make a 360deg butt weld a little overview if i fiind somebody to hold the cam, i'll make a short vid today but the thing is the next chassis to optimize the weight distribution is nearly done. the CAD- Work for that revotruggy thing is in a phase to show you guys (in a new Thread) Last edited by Delta Maxx; 04.18.2011 at 11:22 AM.