RC-Monster Forums - View Single Post - Soldering/Wiring/Ice ESC/Bullets PROBLEMS & QUERIES

Jahay · 04.19.2011, 06:16 PM

THANK YOU ALL FOR CHIMING IN...but

Im a little confused with all your replies... Let me just get this right first...

Is this how it should be set up? i have included my pistix adaptor.

I have chopped the original tinned ends and made my own smaller ends, YET THEY STILL DONT FIT. It is as if the place for the tinned end is much too small!

Everyone with ICE HV use 6.5mm bullets for the motor connectors and 5.5mm bullets for their lipos right?

Its 0.75mm too small in diameter and the wire cannot compress any smaller...

	(#12)
Jahay RC-Monster Titanium Offline Posts: 1,007 Join Date: Apr 2010	04.19.2011, 06:16 PM THANK YOU ALL FOR CHIMING IN...but Im a little confused with all your replies... Let me just get this right first... Is this how it should be set up? i have included my pistix adaptor. I have chopped the original tinned ends and made my own smaller ends, YET THEY STILL DONT FIT. It is as if the place for the tinned end is much too small! Everyone with ICE HV use 6.5mm bullets for the motor connectors and 5.5mm bullets for their lipos right? Its 0.75mm too small in diameter and the wire cannot compress any smaller...