RC-Monster Forums - View Single Post - My HS-7955TG jitters when I turn on the TX... why?

Nixpus · 10:19 AM

Hola amigos!

I just tried to setup my TX/RX and servo for a Savage build... unfortunately the servo start to jitter and is noisy when I turn the TX on :(

The TX/RX combo is this one from HK: http://www.hobbyking.com/hobbyking/s...dProduct=16199

The servo is this oe from Hitec: http://www.hitecrcd.com/products/dig...hs-7955tg.html

It must be related to the servo being digital... since my old analogue acoms servo is silent and jitter free when i plug it into the RX and turn on the TX.

The jittery behaviour is without any load.

Any help would be greatly appreciated :)

	(#1)
Nixpus RC-Monster Carbon Fiber Offline Posts: 138 Join Date: May 2009 Location: Denmark	My HS-7955TG jitters when I turn on the TX... why? - 05.04.2011, 10:19 AM Hola amigos! I just tried to setup my TX/RX and servo for a Savage build... unfortunately the servo start to jitter and is noisy when I turn the TX on :( The TX/RX combo is this one from HK: http://www.hobbyking.com/hobbyking/s...dProduct=16199 The servo is this oe from Hitec: http://www.hitecrcd.com/products/dig...hs-7955tg.html It must be related to the servo being digital... since my old analogue acoms servo is silent and jitter free when i plug it into the RX and turn on the TX. The jittery behaviour is without any load. Any help would be greatly appreciated :) Last edited by Nixpus; 05.04.2011 at 10:19 AM. Reason: Brain fart