RC-Monster Forums - View Single Post

_paralyzed_ · 06.20.2011, 07:47 PM

Did these problems exist before the xerun esc?

Did these problems start immediately after the install of the new esc?

If the problems started with the install of the new esc, it is most probably a wiring problem.

A demagnetized motor is permanently damaged and cannot be fixed, this happens by getting them too hot.

Try your old esc, or have another go at soldering.

	(#15)
_paralyzed_ working on a brushless for my wheelchair..... Offline Posts: 4,890 Join Date: Mar 2007 Location: minnesnowta	06.20.2011, 07:47 PM Did these problems exist before the xerun esc? Did these problems start immediately after the install of the new esc? If the problems started with the install of the new esc, it is most probably a wiring problem. A demagnetized motor is permanently damaged and cannot be fixed, this happens by getting them too hot. Try your old esc, or have another go at soldering. _______________________________________ It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper.