RC-Monster Forums - View Single Post

cmac · 07.24.2011, 09:00 AM

OK, next problem. I was test fitting the hinge pins through all theUE A-Arms this morning they went through all of them except one. In one of the upper A-Arms the middle guide seems to be just a hair off. It does not appear bent. Do I run a drill bit through it knowing that hole will be just a little bit larger? If I do that will it weaken the integrity of the arm?

	(#109)
cmac RC-Monster Carbon Fiber Offline Posts: 401 Join Date: May 2011 Location: Houston Tx,USA	07.24.2011, 09:00 AM OK, next problem. I was test fitting the hinge pins through all theUE A-Arms this morning they went through all of them except one. In one of the upper A-Arms the middle guide seems to be just a hair off. It does not appear bent. Do I run a drill bit through it knowing that hole will be just a little bit larger? If I do that will it weaken the integrity of the arm?