[Overdriven]

I don't know about the UE pins, but lunsford will bend. Its not the pin's fault, its the design of the bulkhead and the fact it doesn't support the lower hinge pin at both ends. I believe the VBS from UE fixes this issue, I know the FLM bulks don't. Either way, I tear down my rc's over the winter, and one of the things I always had to do to the Maxx trucks was straighten the hinge pins. I put them on the flat part of my anvil and hammer down on the high spots till they're straight again. The titanium will get dinged up less and withstand a few more straightening sessions than the steel but its not worth the extra dough in my opinion. Sweet truck btw