RC-Monster Forums - View Single Post - Rummy's Savage E-5SC

NickRummy · 09.06.2011, 12:29 PM

The piece to the right is a drilling fixture. The axles require a new hole to be drilled in them for the baja 4mm pin. Basically slide the xl axle into the fixture, put a wheel nut on to hold it in place and then drill a hole through the opening in the fixture.

	(#15)
NickRummy RC-Monster Carbon Fiber Offline Posts: 209 Join Date: Sep 2008	09.06.2011, 12:29 PM The piece to the right is a drilling fixture. The axles require a new hole to be drilled in them for the baja 4mm pin. Basically slide the xl axle into the fixture, put a wheel nut on to hold it in place and then drill a hole through the opening in the fixture.