RC-Monster Forums - View Single Post - its been a while! --slash 4x4 problems--

t-maxxracer32 · 10.21.2011, 09:10 PM

update........ I remembered back in the day if my motor mount screws were too far inside the motor it would cog, so I decided to take the motor out and mess around with the screws and such (I was almost 100% this was irrelevant but decided to go for it.. had nothing to lose), and once I had it open I turned it on, tried spinning the motor while it was not attached to the drive train and it actually spun for like 2 seconds at most then died out as if the battery had no juice. (I charged a 2500 3s batt up to like 1000 mah)

So Im charging up a different 2s pack to see if this changes anything......

still confused because my nimh pack wont even power it on. Maybe I need to do some cycles with my packs.

	(#2)
t-maxxracer32 RC-Monster Brushless Offline Posts: 2,184 Join Date: Nov 2006	10.21.2011, 09:10 PM update........ I remembered back in the day if my motor mount screws were too far inside the motor it would cog, so I decided to take the motor out and mess around with the screws and such (I was almost 100% this was irrelevant but decided to go for it.. had nothing to lose), and once I had it open I turned it on, tried spinning the motor while it was not attached to the drive train and it actually spun for like 2 seconds at most then died out as if the battery had no juice. (I charged a 2500 3s batt up to like 1000 mah) So Im charging up a different 2s pack to see if this changes anything...... still confused because my nimh pack wont even power it on. Maybe I need to do some cycles with my packs.