RC-Monster Forums - View Single Post

thirdcliff · 02:00 PM

Sounds like a pretty sweet second truck! You should start another build thread for that project.

Hey Mike, I just ordered my slipperential and UCD mount and I already got the Ofna 131mm and the Duratrax 83mm center shafts. I was going to see if you could measure the holes where you mounted the UCD mount onto the center skid plate for me, so I could use the same center shafts?

(Pretty Please!!) Also, do I need to contact Monster Mike about obtaining the right length upper bracket for the UCD mount? As I noticed you had problems with fitting the slipperential into the UCD mount on page 3.

Any help here will get me going a little smoother. Thanks in advance, and I am going to start my build soon and hope to finish over the winter time while work is slow.

	(#12)
thirdcliff RC-Monster Stock Offline Posts: 13 Join Date: Jul 2011 Location: Austin, TX	10.29.2011, 01:47 PM Sounds like a pretty sweet second truck! You should start another build thread for that project. Hey Mike, I just ordered my slipperential and UCD mount and I already got the Ofna 131mm and the Duratrax 83mm center shafts. I was going to see if you could measure the holes where you mounted the UCD mount onto the center skid plate for me, so I could use the same center shafts? (Pretty Please!!) Also, do I need to contact Monster Mike about obtaining the right length upper bracket for the UCD mount? As I noticed you had problems with fitting the slipperential into the UCD mount on page 3. Any help here will get me going a little smoother. Thanks in advance, and I am going to start my build soon and hope to finish over the winter time while work is slow. Last edited by thirdcliff; 10.29.2011 at 02:00 PM.