I was very sleek about hiding that 2 foot antenna (scheesh!). Took a bit of creativity!
antenna/esc signal wires...
Mounting the dang receiver was not easy. It almost seemed impossible with the very low sitting body. I needed to mount the receiver in a way not to make the body bulge. I had to remove the vintage Parma servo saver (dang!) and re-route the servo link (better geometry now though). End result, it all just barely fits!!
servo link screw about .5mm from upper chassis!!
receiver JUST touching
Servo just touching also.
And finally...
Donor next to the shelf queen. Taken just before the donor was shipped out. :(