RC-Monster Forums - View Single Post

MiRatlhed · 11.25.2011, 06:21 PM

Got my new Turnigy LiFe packs today. I wanted to go with these packs because for the no fire aspect on this truck! DO NOT want this thing burnt to a crisp because of some LiPo malfunction!
Also been dying to test one of these packs in one of my Race Clods to see what kind of laps I can lay down with one.

Pics! Enjoy!!

Got the Goo Gone out and took the labels off so I could have the wires on the same side of the chassis for symmetrical purposes.....hehe

Got the Deans installed :

Into the chassis, going to have to have a slight piece of foam under them to keep them from moving around. I had to install some spacers under the cradle posts to get them up far enough to secure with the clip. I used some of the stand offs you get with a set of SuperShocks and took a Black Sharpie to em! But they fit great.

Put a Dace anodize Servo Clamp on the top of the servo case to harness the wire up. This Robot Servo had a threaded mount on top of the case so it was a perfect install.

Time to see how much she weighs...

Next is to get a Tekin Hotwire so I can program the ESC and test it out! Thanks everybody for following my build thread!

	(#107)
MiRatlhed RCMTC-MI Offline Posts: 198 Join Date: Apr 2009 Location: Vermontville, Mi	11.25.2011, 06:21 PM Got my new Turnigy LiFe packs today. I wanted to go with these packs because for the no fire aspect on this truck! DO NOT want this thing burnt to a crisp because of some LiPo malfunction! Also been dying to test one of these packs in one of my Race Clods to see what kind of laps I can lay down with one. Pics! Enjoy!! Got the Goo Gone out and took the labels off so I could have the wires on the same side of the chassis for symmetrical purposes.....hehe Got the Deans installed : Into the chassis, going to have to have a slight piece of foam under them to keep them from moving around. I had to install some spacers under the cradle posts to get them up far enough to secure with the clip. I used some of the stand offs you get with a set of SuperShocks and took a Black Sharpie to em! But they fit great. Put a Dace anodize Servo Clamp on the top of the servo case to harness the wire up. This Robot Servo had a threaded mount on top of the case so it was a perfect install. Time to see how much she weighs... Next is to get a Tekin Hotwire so I can program the ESC and test it out! Thanks everybody for following my build thread!