RC-Monster Forums - View Single Post

Brow · 12.23.2011, 07:41 PM

No more updates yet. Between kids and work I have not had much time to do anything with the cars. The next thing is to fit the plastic spur and come up with a new/changed wheelie bar setup to keep the nose down a bit.

On a side not I am starting to put a rig together to turn down a 1521 Neu 8mm shaft to 5mm using unused savage mounts, a cheap ESC and a servo tester all mounted on a board then using my rotary tool. A bit like a lathe setup - this is taking up what little time I have at the moment and that motor is for another long term project although I might throw it in the savage for a laugh session.

	(#5)
Brow RC Drag racer Offline Posts: 113 Join Date: May 2008 Location: Brisbane, Australia	12.23.2011, 07:41 PM No more updates yet. Between kids and work I have not had much time to do anything with the cars. The next thing is to fit the plastic spur and come up with a new/changed wheelie bar setup to keep the nose down a bit. On a side not I am starting to put a rig together to turn down a 1521 Neu 8mm shaft to 5mm using unused savage mounts, a cheap ESC and a servo tester all mounted on a board then using my rotary tool. A bit like a lathe setup - this is taking up what little time I have at the moment and that motor is for another long term project although I might throw it in the savage for a laugh session.