RC-Monster Forums - View Single Post

rawfuls · 08.08.2012, 01:22 AM

Set the HPF to 100Hz, and cranked level to about 30%, Phase midway (what does phase do..) and same with Frequency (and what does this do? :p)

Thing sounds awesome!
Much better than before, and now I may have gotten the car audio bug, because I'm thinking about front speakers!

Whenever a nice boomy song comes on, the sub definitely overdoes the speakers, so it's kind of hard to hear, I suspect just turning the level down will cure that..

Other than that, it's awesome!

During installation, though, need to clean the wiring up, bad!
Going to need to isolate each connection just for my peace of mind the way I drive.
Also ,when I was finishing the install and pushing everything in the back, I crushed my seat down onto the RCA connector, and snapped one of them right into the socket.
The center pin is now stuck in the sub, and the other channel is a little crooked, but works.

I'm guessing I'll need to find a way to pull the pin out, and put on new RCAs (definitely).
Going to see if I can find some 90degree ones..

	(#36)
rawfuls roofles. Offline Posts: 1,982 Join Date: Oct 2008 Location: Woodland Hills, CA	08.08.2012, 01:22 AM Set the HPF to 100Hz, and cranked level to about 30%, Phase midway (what does phase do..) and same with Frequency (and what does this do? :p) Thing sounds awesome! Much better than before, and now I may have gotten the car audio bug, because I'm thinking about front speakers! Whenever a nice boomy song comes on, the sub definitely overdoes the speakers, so it's kind of hard to hear, I suspect just turning the level down will cure that.. Other than that, it's awesome! During installation, though, need to clean the wiring up, bad! Going to need to isolate each connection just for my peace of mind the way I drive. Also ,when I was finishing the install and pushing everything in the back, I crushed my seat down onto the RCA connector, and snapped one of them right into the socket. The center pin is now stuck in the sub, and the other channel is a little crooked, but works. I'm guessing I'll need to find a way to pull the pin out, and put on new RCAs (definitely). Going to see if I can find some 90degree ones..