RC-Monster Forums - View Single Post - Has anyone succesfully re-attached magnet/rotor to shaft

crazyjr · 03:51 PM

Done it twice myself, both successful and using JBWeld. one was a 4400 hv Novak Emaxx motor ( 550 sc motor), the other was a Lehner 1200 xl basic. Still have the basic and it still running hard. All i did was clean the old glue/ sealer out, being careful to not loosen the tolerances. I prefer the JBWeld over the lockers, due to there being some metal in the stuff, making the bond supposedly stronger

	(#12)
crazyjr RC-Monster Dual Brushless Offline Posts: 3,794 Join Date: May 2005 Location: georgia	09.21.2012, 03:48 PM Done it twice myself, both successful and using JBWeld. one was a 4400 hv Novak Emaxx motor ( 550 sc motor), the other was a Lehner 1200 xl basic. Still have the basic and it still running hard. All i did was clean the old glue/ sealer out, being careful to not loosen the tolerances. I prefer the JBWeld over the lockers, due to there being some metal in the stuff, making the bond supposedly stronger Work because i gotta, play because i wanna People here hate Nitro, I love it. I start it, run it about 50 ft from me and it dies, I go after it. Perfect exercise Last edited by crazyjr; 09.21.2012 at 03:51 PM.