RC-Monster Forums - View Single Post

magman · 09:15 AM

I just ran #'s through the calc...w/your setup using a 13t pinion you are looking at 32mph, w/a 18t pinion you are looking at 44mph. The only issue is the motor RPM which is spinning over 43K which is too much IMO if you want the motor to last.

On a 6s setup a 1300-1500kv motor is best for longevity and good performance. If pure speed runs are what you are after, well then that's a whole different setup.

Just my 2cents worth

	(#5)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	10.05.2012, 09:13 AM I just ran #'s through the calc...w/your setup using a 13t pinion you are looking at 32mph, w/a 18t pinion you are looking at 44mph. The only issue is the motor RPM which is spinning over 43K which is too much IMO if you want the motor to last. On a 6s setup a 1300-1500kv motor is best for longevity and good performance. If pure speed runs are what you are after, well then that's a whole different setup. Just my 2cents worth 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S Last edited by magman; 10.05.2012 at 09:15 AM.