RC-Monster Forums - View Single Post

Brokenparts · 04:42 PM

The only thing that I can think of that I did differently was. Last night I put one lipo on long term storage and left the other one alone. They were both fully decharged, the LVC on the esc stopped the run. This morning I charged them both like I normally do at 3.5amps and ran it.

One of the cells was slightly lower then the others after the full run yesterday.

Cell 1- 3.78
Cell 2- 3.71
Cell 3- 3.70
Cell 4- 3.52

None of the electronics get hot when I run and the motor is warm to the touch.The only other thing I can think of is the new firmware. I'm running 1.38 (beta) and not 1.32. Its the only thing I havent switched yet.

	(#2)
Brokenparts RC-Monster Carbon Fiber Offline Posts: 101 Join Date: Oct 2012	11.03.2012, 04:36 PM The only thing that I can think of that I did differently was. Last night I put one lipo on long term storage and left the other one alone. They were both fully decharged, the LVC on the esc stopped the run. This morning I charged them both like I normally do at 3.5amps and ran it. One of the cells was slightly lower then the others after the full run yesterday. Cell 1- 3.78 Cell 2- 3.71 Cell 3- 3.70 Cell 4- 3.52 None of the electronics get hot when I run and the motor is warm to the touch.The only other thing I can think of is the new firmware. I'm running 1.38 (beta) and not 1.32. Its the only thing I havent switched yet. Last edited by Brokenparts; 11.03.2012 at 04:42 PM.