RC-Monster Forums - View Single Post - problem with mamba 1.38 beta, and castle bad service

magman · 01.10.2013, 07:51 PM

Try going back to an older firmware version. I use a MMM v3 and still use 1.24. You can always revert back to the original firmware that the controller came with. I experiment with newer versions of the firmware and sometimes I go back and forth on which ones "feel better" for my driving style and or which ones don't work so well

On a side note....the MMP you are using in the Flux is a bit small of a esc IMO due to the trucks weight. Be VERY careful of temps and check often!

Good luck!

	(#2)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	01.10.2013, 07:51 PM Try going back to an older firmware version. I use a MMM v3 and still use 1.24. You can always revert back to the original firmware that the controller came with. I experiment with newer versions of the firmware and sometimes I go back and forth on which ones "feel better" for my driving style and or which ones don't work so well On a side note....the MMP you are using in the Flux is a bit small of a esc IMO due to the trucks weight. Be VERY careful of temps and check often! Good luck! 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S