RC-Monster Forums - View Single Post - Kyosho Inferno GT2 VE - Big-Block Edition

Lizard · 06.20.2015, 02:23 PM

Now that you had bad luck going with the low KV/RPM route maybe really try the opposite? The newer TPPowers seem to have higher RPM ratings, even the 5860 can go up to 50k. I'm wondering if those reinforced magnet holders the MBP-RC guy is talking about on his page are now being used again for all TP motors or only the MBP-RC versions. Maybe get one from him if you want to be on the safe side with high RPMs.

Oh, and there is a guy on a german forum who got a TP4070 2200KV and is running it on 6s with an XL2 in a Robitronic Hurricane. Seems to hold up so far but not too much info there about gearing, temps etc.

	(#8)
Lizard RC-Monster Carbon Fiber Offline Posts: 197 Join Date: Jul 2013 Location: Germany	06.20.2015, 02:23 PM Now that you had bad luck going with the low KV/RPM route maybe really try the opposite? The newer TPPowers seem to have higher RPM ratings, even the 5860 can go up to 50k. I'm wondering if those reinforced magnet holders the MBP-RC guy is talking about on his page are now being used again for all TP motors or only the MBP-RC versions. Maybe get one from him if you want to be on the safe side with high RPMs. Oh, and there is a guy on a german forum who got a TP4070 2200KV and is running it on 6s with an XL2 in a Robitronic Hurricane. Seems to hold up so far but not too much info there about gearing, temps etc.