RC-Monster Forums - View Single Post

ruudxd · 08.16.2015, 04:02 PM

It is a total different motor, but my original Caste 1717 5mm shaft is turnded down from a 6mm, so the bearings etc use 6mm holes.
I think this is because they had a 6mm heli version, so they had a lot of rotors, and it was cheaper to turn the original ones down to 5mm then make a lot of 5mm ones, maybe that is the case with TP to?
That they had a lot of 6mm or 8mm rotors laying around, or already being made for other motors?

	(#56)
ruudxd RC-Monster Carbon Fiber Offline Posts: 235 Join Date: Nov 2012 Location: The Netherlands.	08.16.2015, 04:02 PM It is a total different motor, but my original Caste 1717 5mm shaft is turnded down from a 6mm, so the bearings etc use 6mm holes. I think this is because they had a 6mm heli version, so they had a lot of rotors, and it was cheaper to turn the original ones down to 5mm then make a lot of 5mm ones, maybe that is the case with TP to? That they had a lot of 6mm or 8mm rotors laying around, or already being made for other motors?