RC-Monster Forums - View Single Post

Lizard · 11.12.2015, 01:03 PM

hmm. Good question, I don't remember changing the wires. But if you say they come with 10AWG I must've changed them obviously :)

Regarding the soldering. Was done with a cheap 60W conrad Iron, I think a 100w one would've been better. In the middle where I joined the cells, there is a piece of copper under the solder blob.

Regarding safety: I put several layers of tape everywhere and bent up those paper insulation thingies so I couldn't short something accidently. Also the lipos were discharged and I did it right next to the open balcony door, just in case :)

	(#84)
Lizard RC-Monster Carbon Fiber Offline Posts: 197 Join Date: Jul 2013 Location: Germany	11.12.2015, 01:03 PM hmm. Good question, I don't remember changing the wires. But if you say they come with 10AWG I must've changed them obviously :) Regarding the soldering. Was done with a cheap 60W conrad Iron, I think a 100w one would've been better. In the middle where I joined the cells, there is a piece of copper under the solder blob. Regarding safety: I put several layers of tape everywhere and bent up those paper insulation thingies so I couldn't short something accidently. Also the lipos were discharged and I did it right next to the open balcony door, just in case :)