RC-Monster Forums - View Single Post - HV-Maxx motor thermal shutdown problem

RC-Monster Mike · 03.27.2005, 10:09 AM

I can help you in a few ways. First, you can buy the controller from me and I can have it shipped direct from germany to you, so you will save the customs fees. I have this arrangement with BK already. For 14 cell operation, the 9L is the best performer, and it is available with the 1/8" shaft. I have a couple heatsinks left in stock (2 or 3 until Monday or Tuesday when I will get more in stock). You would be able to use the controllers BEC on 14 cells. For slightly better steering performance, you could also use the UBEC (allows slightly higher voltage to the servos).
Don't ever worry that you are asking too many questions. I put the forums here so these questions could be answered. :)

	(#7)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	03.27.2005, 10:09 AM I can help you in a few ways. First, you can buy the controller from me and I can have it shipped direct from germany to you, so you will save the customs fees. I have this arrangement with BK already. For 14 cell operation, the 9L is the best performer, and it is available with the 1/8" shaft. I have a couple heatsinks left in stock (2 or 3 until Monday or Tuesday when I will get more in stock). You would be able to use the controllers BEC on 14 cells. For slightly better steering performance, you could also use the UBEC (allows slightly higher voltage to the servos). Don't ever worry that you are asking too many questions. I put the forums here so these questions could be answered. :)