|
01.29.2017, 07:57 PM
Not sure if possible in aluminum, but my brother once used JB Weld on a Car Crank (cast iron) to reform the threads for the dampener. He slathered it on the bolt and Snugged it down, waited 24 hours, removed the bolt and reinstalled the dampener. It held till he disassembled the engine, 3 years later. The threads still looked perfect
Work because i gotta, play because i wanna
People here hate Nitro, I love it. I start it, run it about 50 ft from me and it dies, I go after it. Perfect exercise
|